FPVDrone M8N GPS Module Built-in Compass with GPS Antenna Mount for APM 2.6 APM 2.8 Pixhawk Flight Controller
|
상품가격 상세보기
이벤트보기
|
- 상품상세정보
상품특징
★M8N GPS Module for APM2.6 APM2.8 Flight Controller.★A new generation M8N GPS Module,with low power consumption and high precision.★The M8N and ceramic antenna make this a very accurate receiver,fast locks & lots of satellites.★★★Note:it is default for APM flight controller,if you use with Pixhawk flight controller,you need to change the connector by yourself.★★★Note:When use 2.8 boards with our GPS module must remove the jumper,if you need to calibrate,make the control and GPS compass direction same and keep the two position fixed(cannot make any move,must fix them on quadcopter and then calibrate,or it will be failed.)
상품설명
GPS Chip parameters: Receiver type 72-channel u-blox M8 engine GPS/QZSS L1 C/A, GLONASS L10F, BeiDou B1 SBAS L1 C/A: WAAS, EGNOS, MSAS Galileo-ready E1B/C (GPS M8N) Nav. update rate1 Single GNSS: up to 18 HZ Concurrent GNSS: up to 10 Hz Position accuracy2 2.0 m CEP Acquisition2 Cold starts: 26 s Aided starts: 2 s Reacquisition: 1.5 s Sensitivity2 Tracking & Nav: –167 dBm Cold starts: –148 dBm Hot starts: –156 dBm Assistance AssistNow GNSS Online AssistNow GNSS Offline (up to 35 days)3 AssistNow Autonomous (up to 6 days) OMA SUPL & 3GPP compliant Oscillator TCXO (GPS M8N/Q), Crystal (GPS M8M) RTC crystal Built-In Noise figure On-chip LNA (GPS M8M). Extra LNA for lowest noise figure (GPS M8N/Q) Anti jamming Active CW detection and removal. Extra onboard SAW band pass filter (GPS M8N/Q) Memory ROM (GPS M8M/Q) or Flash (GPS M8N) Supported antennas Active and passive Odometer Travelled distance Data-logger For position, velocity, and time (GPS M8N) Operating temp. –40° C to 85° C Storage temp. –40° C to 85° C (GPS M8N/Q) –40° C to 105° C (GPS M8M) RoHS compliant (lead-free) Qualification according to ISO 16750 Manufactured and fully tested in ISO/TS 16949 certified production sites Uses u-blox M8 chips qualified according to AEC-Q100 Supply voltage 1.65 V to 3.6 V (GPS M8M) 2.7 V to 3.6 V (GPS M8N/Q) Power consumption4 23 mA @ 3.0 V (continuous) 5 mA @ 3.0 V Power Save Mode (1 Hz, GPS mode only) Backup Supply 1.4 to 3.6 V GPS M8N-0 GPS M8 Concurrent GNSS LCC Module, TCXO, flash, SAW, LNA, Timepulse Configurable 0.25 Hz to 10 MHz Package including: - 1 x M8N GPS Module for APM Flight Controller 1 x GPS Antenna Mount
★M8N GPS Module for APM2.6 APM2.8 Flight Controller.★A new generation M8N GPS Module,with low power consumption and high precision.★The M8N and ceramic antenna make this a very accurate receiver,fast locks & lots of satellites.★★★Note:it is default for APM flight controller,if you use with Pixhawk flight controller,you need to change the connector by yourself.★★★Note:When use 2.8 boards with our GPS module must remove the jumper,if you need to calibrate,make the control and GPS compass direction same and keep the two position fixed(cannot make any move,must fix them on quadcopter and then calibrate,or it will be failed.)
상품설명
GPS Chip parameters: Receiver type 72-channel u-blox M8 engine GPS/QZSS L1 C/A, GLONASS L10F, BeiDou B1 SBAS L1 C/A: WAAS, EGNOS, MSAS Galileo-ready E1B/C (GPS M8N) Nav. update rate1 Single GNSS: up to 18 HZ Concurrent GNSS: up to 10 Hz Position accuracy2 2.0 m CEP Acquisition2 Cold starts: 26 s Aided starts: 2 s Reacquisition: 1.5 s Sensitivity2 Tracking & Nav: –167 dBm Cold starts: –148 dBm Hot starts: –156 dBm Assistance AssistNow GNSS Online AssistNow GNSS Offline (up to 35 days)3 AssistNow Autonomous (up to 6 days) OMA SUPL & 3GPP compliant Oscillator TCXO (GPS M8N/Q), Crystal (GPS M8M) RTC crystal Built-In Noise figure On-chip LNA (GPS M8M). Extra LNA for lowest noise figure (GPS M8N/Q) Anti jamming Active CW detection and removal. Extra onboard SAW band pass filter (GPS M8N/Q) Memory ROM (GPS M8M/Q) or Flash (GPS M8N) Supported antennas Active and passive Odometer Travelled distance Data-logger For position, velocity, and time (GPS M8N) Operating temp. –40° C to 85° C Storage temp. –40° C to 85° C (GPS M8N/Q) –40° C to 105° C (GPS M8M) RoHS compliant (lead-free) Qualification according to ISO 16750 Manufactured and fully tested in ISO/TS 16949 certified production sites Uses u-blox M8 chips qualified according to AEC-Q100 Supply voltage 1.65 V to 3.6 V (GPS M8M) 2.7 V to 3.6 V (GPS M8N/Q) Power consumption4 23 mA @ 3.0 V (continuous) 5 mA @ 3.0 V Power Save Mode (1 Hz, GPS mode only) Backup Supply 1.4 to 3.6 V GPS M8N-0 GPS M8 Concurrent GNSS LCC Module, TCXO, flash, SAW, LNA, Timepulse Configurable 0.25 Hz to 10 MHz Package including: - 1 x M8N GPS Module for APM Flight Controller 1 x GPS Antenna Mount
2019-04-03 17:04:50