Uniquers Liquid Flow Meter Water Flow Hall Effect Sensor Switch Flowmeter Counter- Plastic 1/2" NPS Threaded
|
|
상품가격 상세보기
이벤트보기
|
- 상품상세정보
상품특징
1/2" NPS nominal pipe connections0.78" outer diameter1/2" of threadSize: 2.5" x 1.4" x 1.4"
상품설명
Measure liquid/water flow for your solar, computer cooling, or gardening project using this handy basic flow meter. This sensor sit in line with your water line, and uses a pinwheel sensor to measure how much liquid has moved through it. The pinwheel has a little magnet attached, and there\'s a hall effect magnetic sensor on the other side of the plastic tube that can measure how many spins the pinwheel has made through the plastic wall. This method allows the sensor to stay safe and dry. The sensor comes with three wires: red (5-24VDC power), black (ground) and yellow (Hall effect pulse output). By counting the pulses from the output of the sensor, you can easily track fluid movement: each pulse is approximately 2.25 milliliters. Note this isn\'t a precision sensor, and the pulse rate does vary a bit depending on the flow rate, fluid pressure and sensor orientation. It will need careful calibration if better than 10% precision is required. However, its great for basic measurement tasks! Electrical: Working Voltage: 5 to 18VDC Max current draw: 15mA @ 5V Working Flow Rate: 1 to 30 Liters/Minute Working Temperature range: -25 to 80°C Working Humidity Range: 35%-80% RH Maximum water pressure: 2.0 MPa Output duty cycle: 50% +-10% Output rise time: 0.04us Output fall time: 0.18us Flow rate pulse characteristics: Frequency (Hz) = 7.5 * Flow rate (L/min) Pulses per Liter: 450 Durability: minimum 300,000 cycles
1/2" NPS nominal pipe connections0.78" outer diameter1/2" of threadSize: 2.5" x 1.4" x 1.4"
상품설명
Measure liquid/water flow for your solar, computer cooling, or gardening project using this handy basic flow meter. This sensor sit in line with your water line, and uses a pinwheel sensor to measure how much liquid has moved through it. The pinwheel has a little magnet attached, and there\'s a hall effect magnetic sensor on the other side of the plastic tube that can measure how many spins the pinwheel has made through the plastic wall. This method allows the sensor to stay safe and dry. The sensor comes with three wires: red (5-24VDC power), black (ground) and yellow (Hall effect pulse output). By counting the pulses from the output of the sensor, you can easily track fluid movement: each pulse is approximately 2.25 milliliters. Note this isn\'t a precision sensor, and the pulse rate does vary a bit depending on the flow rate, fluid pressure and sensor orientation. It will need careful calibration if better than 10% precision is required. However, its great for basic measurement tasks! Electrical: Working Voltage: 5 to 18VDC Max current draw: 15mA @ 5V Working Flow Rate: 1 to 30 Liters/Minute Working Temperature range: -25 to 80°C Working Humidity Range: 35%-80% RH Maximum water pressure: 2.0 MPa Output duty cycle: 50% +-10% Output rise time: 0.04us Output fall time: 0.18us Flow rate pulse characteristics: Frequency (Hz) = 7.5 * Flow rate (L/min) Pulses per Liter: 450 Durability: minimum 300,000 cycles
2019-03-30 12:04:09
