Lectrosonics HMa UHF Plug-On Wireless Transmitter, Frequency Band B1 (537.600-614.375MHz)
|
상품가격 상세보기
이벤트보기
|
- 상품상세정보
상품특징
Lectrosonics HMa UHF Plug-On Wireless Transmitter - PHTRAN3 Leather Pouch - 2x AA Alkaline Batteries - Quickstart Guide - Lectrosonics 1 Year Parts and Labor Limited WarrantyAccepts microphone or line level signalsSelectable 5, 15, 48 volt phantom power76MHz tuning range in 100kHz or 25kHz steps for up to 3072 frequenciesSelectable 50/100mW output power
상품설명
This unique plug-on transmitter design will ideally match any microphone or line level source via a standard XLR connector. Phantom power is selectable at 5, 15 and 48 volts or can be turned off for use with dynamic microphones and line level signal sources. The design includes a wide tuning range of up to 76 MHz, with tuning steps in increments of 100 kHz or 25 kHz for up to 3072 frequencies. The tuning range covers three standard 25.6 MHz Lectrosonics frequency bands. Each of the standard bands includes 256 different pilot tone frequencies for compatibility with all Digital Hybrid Wireless receivers. DSP compatibility modes are also included to work with legacy Lectrosonics analog wireless microphone receivers and IFB receivers, as well as some receivers from other manufacturers. The transmitter is powered by two AA batteries, with status indicated by a multi-color LED. A USB port is provided for firmware updates. An IR (infrared) port is also included to simplify setup with IR enabled receivers. The input amplifier uses an ultra low noise op-amp for quiet operation. It is gain controlled with a wide range dual envelope limiter, providing over 30 dB of headroom above full modulation. A 24-bit A-D converter digitizes the audio, then filters supersonic noise above 21 kHz. The resulting signal is encoded with a proprietary algorithm to produce an analog data signal for RF transmission. The underlying RF link is an optimized FM system with +/-
Lectrosonics HMa UHF Plug-On Wireless Transmitter - PHTRAN3 Leather Pouch - 2x AA Alkaline Batteries - Quickstart Guide - Lectrosonics 1 Year Parts and Labor Limited WarrantyAccepts microphone or line level signalsSelectable 5, 15, 48 volt phantom power76MHz tuning range in 100kHz or 25kHz steps for up to 3072 frequenciesSelectable 50/100mW output power
상품설명
This unique plug-on transmitter design will ideally match any microphone or line level source via a standard XLR connector. Phantom power is selectable at 5, 15 and 48 volts or can be turned off for use with dynamic microphones and line level signal sources. The design includes a wide tuning range of up to 76 MHz, with tuning steps in increments of 100 kHz or 25 kHz for up to 3072 frequencies. The tuning range covers three standard 25.6 MHz Lectrosonics frequency bands. Each of the standard bands includes 256 different pilot tone frequencies for compatibility with all Digital Hybrid Wireless receivers. DSP compatibility modes are also included to work with legacy Lectrosonics analog wireless microphone receivers and IFB receivers, as well as some receivers from other manufacturers. The transmitter is powered by two AA batteries, with status indicated by a multi-color LED. A USB port is provided for firmware updates. An IR (infrared) port is also included to simplify setup with IR enabled receivers. The input amplifier uses an ultra low noise op-amp for quiet operation. It is gain controlled with a wide range dual envelope limiter, providing over 30 dB of headroom above full modulation. A 24-bit A-D converter digitizes the audio, then filters supersonic noise above 21 kHz. The resulting signal is encoded with a proprietary algorithm to produce an analog data signal for RF transmission. The underlying RF link is an optimized FM system with +/-
2019-06-10 21:15:16