Hadronix 1/4 Quick-Connect Food-Grade Water Flow Meter Hall Sensor HDRX-YF-S402B - Connectors Included - Arduino, Raspberry Pi, and Reverse Osmosis Filter Compatible
|
|
상품가격 상세보기
이벤트보기
|
- 상품상세정보
상품특징
Make sure this fits by entering your model number.Food grade; Liquid passed through is safe to drink1/4" OD Quick-Connect; Easy installation and removal, and works with most Reverse Osmosis filtration systemsIncludes 3-pin male 0.1" pitch JST-XH mating connector; Perfect for use on a breadboard with Arduino or Raspberry Pi3.5 - 12 volt supply voltage range; Devices below 3.5 volts can be supported with a simple (not included) voltage divider circuitWorks with pressures up to 116 pounds per square inch and flow rates of 0.3 - 6 liters per minute
상품설명
The HDRX-YF-S402B is a food-grade liquid flow meter. This device is used to measure how much liquid has passed within a duration of time. It uses hall effect sensor and has a 1/4" quick-connect fittings for easy installation and removal. It has 3.5 - 12VDC supply voltage range and is perfect for use in DIY home automation, irrigation, filtration projects and more powered by Arduino and Raspberry Pi. Included with this flow meter is the JST-XH mating connector helps you to get started working with the HDRX YF-S402B right away. The included mated connector has a 2.54mm pitch which is perfect for bread board projects.
Make sure this fits by entering your model number.Food grade; Liquid passed through is safe to drink1/4" OD Quick-Connect; Easy installation and removal, and works with most Reverse Osmosis filtration systemsIncludes 3-pin male 0.1" pitch JST-XH mating connector; Perfect for use on a breadboard with Arduino or Raspberry Pi3.5 - 12 volt supply voltage range; Devices below 3.5 volts can be supported with a simple (not included) voltage divider circuitWorks with pressures up to 116 pounds per square inch and flow rates of 0.3 - 6 liters per minute
상품설명
The HDRX-YF-S402B is a food-grade liquid flow meter. This device is used to measure how much liquid has passed within a duration of time. It uses hall effect sensor and has a 1/4" quick-connect fittings for easy installation and removal. It has 3.5 - 12VDC supply voltage range and is perfect for use in DIY home automation, irrigation, filtration projects and more powered by Arduino and Raspberry Pi. Included with this flow meter is the JST-XH mating connector helps you to get started working with the HDRX YF-S402B right away. The included mated connector has a 2.54mm pitch which is perfect for bread board projects.
2019-03-20 11:55:23
