BIQU MKS Gen L V2.0 3D Printer Integrated Motherboard Controller PCB Board A4988/DRV8825/TMC2208/TMC2130 Like Ramps 1.6 MKS Gen V1.4 Mainboard
|
상품가격 상세보기
이벤트보기
|
- 상품상세정보
상품특징
Make sure this fits by entering your model number.Integrate 2560 and Ramps1.4 one PCB,easier wiring and more stableUse high-quality 4 layer PCB&Use special power chip,support 12V-24V, also Use Marlin firmware,same as configuration way as Ramps1.4, it can replace Ramps1.4 directlySupport a variety of stepper drivers:4988,8825,TMC2208 and TMC2100, and available to work with LCD2004,LCD12864,MKS TFT24/28/32/35 & Available to connect external large stepp driversAccept 24V input,reduce the heated bed current to 1/4 that slove the Mosfet heat problem efficientlyRetail Servos,AUX-1 and AUX-2 interface of Ramps1.4 provide three 5V output and three 12V output interfaces
상품설명
Product Introduction Aiming at the problems exist on the open sourced controller board such as Ramps 1.4, the developers in Makerbase specially optimize and develop a new product, MKS Gen L, which provides more flexible choices for users. Attention 1.Make sure positive and negative connection is all right before powering. 2.No plugging and removing the drivers and motors when powering, otherwise it will easily burn the drivers. 3.No adjusting the driver current when the motors are running. Packing List MKS GEN L V2.0 Board*1 USD Cable*1
Make sure this fits by entering your model number.Integrate 2560 and Ramps1.4 one PCB,easier wiring and more stableUse high-quality 4 layer PCB&Use special power chip,support 12V-24V, also Use Marlin firmware,same as configuration way as Ramps1.4, it can replace Ramps1.4 directlySupport a variety of stepper drivers:4988,8825,TMC2208 and TMC2100, and available to work with LCD2004,LCD12864,MKS TFT24/28/32/35 & Available to connect external large stepp driversAccept 24V input,reduce the heated bed current to 1/4 that slove the Mosfet heat problem efficientlyRetail Servos,AUX-1 and AUX-2 interface of Ramps1.4 provide three 5V output and three 12V output interfaces
상품설명
Product Introduction Aiming at the problems exist on the open sourced controller board such as Ramps 1.4, the developers in Makerbase specially optimize and develop a new product, MKS Gen L, which provides more flexible choices for users. Attention 1.Make sure positive and negative connection is all right before powering. 2.No plugging and removing the drivers and motors when powering, otherwise it will easily burn the drivers. 3.No adjusting the driver current when the motors are running. Packing List MKS GEN L V2.0 Board*1 USD Cable*1
2020-08-20 00:52:56