Highly Accurate Aluminum Tungsten Stick-out Gauge for TIG Welding, Wrapped in Lime Green Powder Paint. Made in USA
|
상품가격 상세보기
이벤트보기
|
- 상품상세정보
상품특징
QUALITY:The only gauge of its kind that\'s made in the USA. Made from 6061 aluminum, drilled to accurate depths, clear markings and face is a bushed finish.FAST: Just follow the 2 easy stepsCONVENIENT: Just 1 gauge for all your calibrating needs. Not 3 like most of the competition.EASY TO USE: Large easy to read numbers. NO squinting and trying to count small lines or numbers.MAKES DUPLICATING PREVIOUS WELDS EASIER
상품설명
Walker Partners, USA made, Tungsten stick-out gauge for TIG welding is fast, accurate, and convenient to use. Because the best starting point for a tungsten stick-out is the diameter of the lens in 16th, simply extend the tip of the tungsten out about 1 1/2 inches, then lightly tighten the back cap. Then place the tip into the hole that corresponds with the number on the lens you are holding. Press down until the lens comes in contact with the gauge. Pull the torch back and tighten the back cap firmly. That\'s all there is to it. The gauge will accept tungsten up to 1/8 inch. The gauge is calibrated to use with the most popular lens, 4, 5, 6, 7, 8, 9, 10, 12, 14, and 16. Works with standard torches, 9, 17, 20, and 26 styles. Brushed aluminum face is wrapped in chip resistant Lime Green powder paint.
QUALITY:The only gauge of its kind that\'s made in the USA. Made from 6061 aluminum, drilled to accurate depths, clear markings and face is a bushed finish.FAST: Just follow the 2 easy stepsCONVENIENT: Just 1 gauge for all your calibrating needs. Not 3 like most of the competition.EASY TO USE: Large easy to read numbers. NO squinting and trying to count small lines or numbers.MAKES DUPLICATING PREVIOUS WELDS EASIER
상품설명
Walker Partners, USA made, Tungsten stick-out gauge for TIG welding is fast, accurate, and convenient to use. Because the best starting point for a tungsten stick-out is the diameter of the lens in 16th, simply extend the tip of the tungsten out about 1 1/2 inches, then lightly tighten the back cap. Then place the tip into the hole that corresponds with the number on the lens you are holding. Press down until the lens comes in contact with the gauge. Pull the torch back and tighten the back cap firmly. That\'s all there is to it. The gauge will accept tungsten up to 1/8 inch. The gauge is calibrated to use with the most popular lens, 4, 5, 6, 7, 8, 9, 10, 12, 14, and 16. Works with standard torches, 9, 17, 20, and 26 styles. Brushed aluminum face is wrapped in chip resistant Lime Green powder paint.
2021-11-20 20:46:56