T862 IRDA SMT SMD BGA Welder Infrared Rework Station
|
상품가격 상세보기
이벤트보기
|
- 상품상세정보
상품특징
Make sure this fits by entering your model number.Adopt infrared weld technology which independent exploration.Use infrared heat,it is easy to cut through,heat proportion piercing tradition weld machine with sirocco.Easily operate.Just need one day training.Can operation this machine.No need weld tools,it can weld all the component of 15x15-35x35mm.Infrared heating no have sirocco flow. Don't impact perimeter scomponent. Can suitable for all of the component,especially Micro BGA component.
상품설명
Features: 1. Adopt infrared weld technology which independent exploration. 2. Use infrared heat,it is easy to cut through,heat proportion piercing tradition weld machine with sirocco. 3. Easily operate.Just need one day training.Can operation this machine. 4. No need weld tools,it can weld all the component of 15x15-35x35mm. 5. This machine has 650W heating system.widely to 120x120mm. 6. Infrared heating no have sirocco flow. Don't impact perimeter scomponent. Can suitable for all of the component,especially Micro BGA component. Open the machine (1) Check if the connection wire of the lamp body and the 936-Iron is ok. (2) Locate and attach the power cable to the rear of the re-work station (3) Confirm all front panel rocker switches are off. (4) Place the rear AC Power Switch in the ON Position. (5) Allow the T-862++ Power-On-Self-Test (POST) to complete. (6) Temperature set-points will display last value used. (7) Place the target PC Board on the slip-rack and orient to close proximity of estimated position of focused Infrared light, (8) Adjust the T-862++ Infrared light system height, allow 20-30mm from lens end to PC board target component. (9) Turn on the two switches. They control warm-up plate and light system.
Make sure this fits by entering your model number.Adopt infrared weld technology which independent exploration.Use infrared heat,it is easy to cut through,heat proportion piercing tradition weld machine with sirocco.Easily operate.Just need one day training.Can operation this machine.No need weld tools,it can weld all the component of 15x15-35x35mm.Infrared heating no have sirocco flow. Don't impact perimeter scomponent. Can suitable for all of the component,especially Micro BGA component.
상품설명
Features: 1. Adopt infrared weld technology which independent exploration. 2. Use infrared heat,it is easy to cut through,heat proportion piercing tradition weld machine with sirocco. 3. Easily operate.Just need one day training.Can operation this machine. 4. No need weld tools,it can weld all the component of 15x15-35x35mm. 5. This machine has 650W heating system.widely to 120x120mm. 6. Infrared heating no have sirocco flow. Don't impact perimeter scomponent. Can suitable for all of the component,especially Micro BGA component. Open the machine (1) Check if the connection wire of the lamp body and the 936-Iron is ok. (2) Locate and attach the power cable to the rear of the re-work station (3) Confirm all front panel rocker switches are off. (4) Place the rear AC Power Switch in the ON Position. (5) Allow the T-862++ Power-On-Self-Test (POST) to complete. (6) Temperature set-points will display last value used. (7) Place the target PC Board on the slip-rack and orient to close proximity of estimated position of focused Infrared light, (8) Adjust the T-862++ Infrared light system height, allow 20-30mm from lens end to PC board target component. (9) Turn on the two switches. They control warm-up plate and light system.
2021-11-26 19:15:53